International Standard
ISO 604:2002
Plastics — Determination of compressive properties
Reference number
ISO 604:2002
Версия 3
International Standard
ISO 604:2002
недоступно на русском языке
Опубликовано (Версия 3, 2002)
Последний раз этот стандарт был пересмотрен в  2022. Поэтому данная версия остается актуальной.

ISO 604:2002

ISO 604:2002
CHF 96
Пересчитать швейцарские франки (CHF) в ваша валюта


This International Standard specifies a method for determining the compressive properties of plastics under defined

conditions. A standard test specimen is defined but its length may be adjusted to prevent buckling under load from

affecting the results. A range of test speeds is included.

The method is used to investigate the compressive behaviour of the test specimens and for determining the

compressive strength, compressive modulus and other aspects of the compressive stress/strain relationship under

the conditions defined.

The method applies to the following range of materials:

 rigid and semi-rigid [1] thermoplastic moulding and extrusion materials, including compounds filled and

reinforced by e.g. short fibres, small rods, plates or granules in addition to unfilled types; rigid and semi-rigid

thermoplastic sheet;

 rigid and semi-rigid thermoset moulding materials, including filled and reinforced compounds; rigid and semirigid

thermoset sheet;

 thermotropic liquid-crystal polymers.

In agreement with ISO 10350-1 and ISO 10350-2, this International Standard applies to fibre-reinforced

compounds with fibre lengths u 7,5 mm prior to processing.

The method is not normally suitable for use with materials reinforced by textile fibres (see references [2] and [5]),

fibre-reinforced plastic composites and laminates (see [5]), rigid cellular materials (see [3]) or sandwich structures

containing cellular material or rubber (see [4]).

The method is performed using specimens which may be moulded to the chosen dimensions, machined from the

central portion of a standard multipurpose test specimen (see ISO 3167) or machined from finished or semifinished

products such as mouldings or extruded or cast sheet.

The method specifies preferred dimensions for the test specimen. Tests which are carried out on specimens of

different dimensions, or on specimens which are prepared under different conditions, may produce results which

are not comparable. Other factors, such as the test speed and the conditioning of the specimens, can also

influence the results. Consequently, when comparable data are required, these factors must be carefully controlled

and recorded.

Общая информация

  •  : Опубликовано
     : 2002-03
    : Подтверждение действия между-народного стандарта [90.93]
  •  : 3
  • ISO/TC 61/SC 2
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)