Reference number
ISO 10300-3:2023
© ISO 2024
International Standard
ISO 10300-3:2023
Calculation of load capacity of bevel gears — Part 3: Calculation of tooth root strength
Edition 3
2023-08
Preview
недоступно на русском языке
Опубликовано (Версия 3, 2023)

ISO 10300-3:2023

Язык
Формат
CHF 173
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

This document specifies the fundamental formulae for use in the tooth root stress calculation of straight and helical (skew), Zerol and spiral bevel gears including hypoid gears, with a minimum rim thickness under the root of 3,5 mmn. All load influences on tooth root stress are included, insofar as they are the result of load transmitted by the gearing and able to be evaluated quantitatively. Stresses, such as those caused by the shrink fitting of gear rims, which are superposed on stresses due to tooth loading, are intended to be considered in the calculation of the tooth root stress, σF, or the permissible tooth root stress σFP. This document is not applicable in the assessment of tooth flank fracture.

The formulae in this document are based on virtual cylindrical gears and restricted to bevel gears whose virtual cylindrical gears have transverse contact ratios of εvα < 2. The results are valid within the range of the applied factors as specified in ISO 10300-1. The bending strength formulae are applicable to fractures at the tooth fillet, but not to those on the active flank surfaces, to failures of the gear rim or of the gear blank through the web and hub.

This document does not apply to stress levels above those permitted for 103 cycles, as stresses in that range can exceed the elastic limit of the gear tooth.

NOTE            This document is not applicable to bevel gears which have an inadequate contact pattern under load.

The user is cautioned that when the formulae are used for large average mean spiral angles (βm1 + βm2)/2 > 45°, for effective pressure angles αe > 30° and/or for large facewidths b > 13 mmn, the calculated results of this document should be confirmed by experience.

Общая информация

  • Текущий статус
     : Опубликовано
    Дата публикации
     : 2023-08
    Этап
    : Опубликование международного стандарта [60.60]
  • Версия
     : 3
  • Технический комитет :
    ISO/TC 60/SC 2
    ICS :
    21.200 
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

  2. Интернет-магазин
  3. Каталог стандартов
  4. МКС
  5. 21
  6. 21.200
  7. ISO 10300-3:2023