Draft
International Standard
ISO/DIS 18954
Steel structures — Structural bolting — Test method to determine parameters of bolt tightening procedures
Reference number
ISO/DIS 18954
Edition 1
© ISO 2025
Проект Международный стандарт
Preview
недоступно на русском языке
В стадии разработки
Проект данного международного стандарта находится на этапе рассмотрения членами ИСО.

ISO/DIS 18954

Язык
Формат
CHF 65
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

This test method is to be used only if no rules and parameters for tightening exist, e.g. for pretensioning of stainless steel bolting assemblies, or when bolts are pretensioned by turning the head. This test method establishes a bolt tightening qualification procedure (BTQP) which provides design and execution rules for pretensioning of stainless steel and carbon steel bolting assemblies with bolting assemblies consisting of one bolt, one nut, and washers as required for the installation method. The test method allows the determination of the tightening parameters for a specific configuration. In this procedure, one configuration is: - One single bolting assembly lot (i.e. bolts from one manufacturing lot, nuts from one manufacturing lot, washers from one manufacturing lot, - One lubrication, and - One tightening method, with a defined pretension level. Testing should be performed for each new configuration. The specified pretension shall not exceed the nominal pretension level. The test method includes: — the definition of appropriate lubrication to ensure a sufficiently long plastic plateau of the bolt force–rotation curve. (The ability to demonstrate the required functional characteristics of the bolting assembly is highly dependent on the type of lubrication used.) — the evaluation of tightening parameters. — a suitability test to confirm that the required pretension can be reliably obtained by a specific tightening method with a sufficient margin of safety against overtightening. This test methods applies only to static design. Fatigue considerations may govern the design should also be assessed.

Общая информация

  • Текущий статус
     : В стадии разработки

    You can help develop this draft international standard by contacting your national member

    Этап
    : Начало голосования по проекту между-народно-го стандарта: 3 мес. [40.20]
  • Версия
     : 1
  • Технический комитет :
    ISO/TC 167
    ICS :
    91.080.13 
  • RSS обновления

Жизненный цикл

Цели в области устойчивого развития

Данный стандарт разработан для достижения следующих Цель устойчивого развития

9
Индустриализация, инновации и инфраструктура

Появились вопросы?

Ознакомьтесь с FAQ

  2. Интернет-магазин
  3. Каталог стандартов
  4. МКС
  5. 91
  6. 91.080
  7. 91.080.13
  8. ISO/DIS 18954